Solution ID: 137852

Sound BlasterX Siege M04: How to Perform a Hardware Reset
Keywords/Keyphrases: reset, hardware reset, factory default, restore, factory reset


  • Applicable to: Sound BlasterX Siege M04 (GP0070)
  • This article shows how to perform a hardware reset for the Sound BlasterX Siege M04. This procedure will restore the mouse's original settings.
  1. Unplug the Sound BlasterX Siege M04 mouse from the powered USB port.

  2. Press and hold the Previous button (left side, lower button) and the Right-click button together before plugging the mouse back to the powered USB port again.

  3. Continue to hold the mouse buttons until the mouse LED turns ON. This completes the hardware reset of the mouse.
Last Updated: April 25, 2017

If you require further assistance, please send an email to technical support.

Note: Product specification, technical or troubleshooting information are subjected to change. This is due to changes and/or updates in the new firmware/driver releases. Please refer to the web release notes in the download section for details.


Was this information helpful?

Your feedback is essential for us to constantly refine our Knowledgebase articles to better support you.
Please take a moment to rate our case.

- Your feedback is received anonymously, and thus cannot be responded to.
Excellent        Good        Average        Poor        Bad